7
1. Loosen the red
Paper Guide
adjustment knobs. Don’t fully remove
them. 1-2 turns clockwise will loosen them.
2. Place a ½” stack of the form to be run on the feed table.
3. Line the paper stack up against the stationery paper guide.
4. Push the moveable paper guide up against the paper stack so that all
the paper is aligned and the paper guide is snug against the side of the
stack.
5. Hold the moveable guide in place with one hand and tighten the
adjustment knobs with the other.
Setting the Feed Gauge
Figure 8: Feed Gauge Cross Section View
To properly set the
Feed Gauge System
[see Figure 8]:
Make sure that the
power switch
is in the
Off
position.
1. Remove all paper from the feed table.
Feed Gauge
Adjustment Screw
Move Feed Belt In This Direction With
Your Hand To Feed The Form In.
Feed Gauge
Roll
(Sample
Form)
Feed Belt
