12
Troubleshooting
Automatically Clearing a Paper Jam
If paper becomes jammed in the
ENDEAVOUR
:
1. Remove all paper from the
Feed Table
.
2. If
the
Power Switch Breaker
has tripped (light is off) then flip into the
on (lighted) position.
3. Remove
the
Lower Fold Plate
.
4. Press
the
Reverse
button.
5. The paper should exit from the back (where the
Lower Fold Plate
normally sits). If it does not, try pressing the
Reverse
button again. If
the paper is not moving or you cannot see it, then you need to
manually clear the jam [see next section].
6. Replace the Lower Fold Plate.
Manually Clearing a Paper Jam
1. Disconnect the power cord from the
ENDEAVOUR
.
Make sure that the power cord has been disconnected before
continuing!
2. Remove all paper from the
Feed Table
.
3. Remove
the
Lower Fold Plate
from the
ENDEAVOUR
.
4. Remove the access panel in the side cover.
5. Place the Breaker Bar socket over the hex end of the #3.
6. Rotate the breaker bar clockwise until the jammed form is out of the
ENDEAVOUR
.
7. Replace
the
Lower Fold Plate
.
8. Replace the paper on the
Feed Table
.
9. Return the breaker bar to the toolkit.
10. Replace the side cover access panel.
11. Make sure that the power switch is in the
Off
position.
12. Connect the power cord to the
ENDEAVOUR
.