Pict. 22: moving one side of the frame forward (increasing the measured value) on the Y axis
and other side backward (decreasing the measured value) according to the values from the
first screen will improve the skew.
8.4 Linear Advance (Experimental)
Linear Advance is the new feature from the firmware version 3.1.0. You don’t need to enable
it or tweaking -
everything is preset
. You just need firmware 3.1.0 and
drivers updated to
1.9.2
or higher.
Thanks to Linear Advance,
all the print settings for MK2/S has slight 10-15 mm/s speed
increase.
New print settings were also added to Slic3r PE for experimental faster printing – 0.15 mm
100 mm/s Linear Advance and 0.20 mm 100 mm/s Linear Advance where speed is
increased even more, up to 100 mm/s, to get additional ~30% faster printing. You do not
need to calibrate or tweak anything to get faster printing, just use these settings to generate
your gcode.
To see the speed increase, you must
test on larger models
! Slic3r limits the minimum
time per layer to 15 seconds and in case it is triggered, print speed is lowered. This
prevents insufficient cooling and ugly prints. Printing one Marvin will not be any faster
than before.
If you are using different slicers than Slic3r PE or PrusaControl or you just want to
tweak and play around with different values, you can manually change the settings
in gcode script.
However, i
f you do not understand the concept of gcodes yet or
never played with editing it, stop reading here and skip for another chapter.
38
Summary of Contents for Original Prusa i3 MK2S 1.75mm
Page 1: ......
Page 25: ...Pict 11 Probe response diagram Now you are done 25 ...
Page 61: ...Pict 35 Nozzle change 61 ...
