6.3.5.1 Calibrate XYZ e
rror messages and resolution
(kit only)
1)
XYZ calibration failed. Bed calibration point was not found.
Calibration routine did not find a bed sensor point. The printer stops close to the bed
point, which it failed to detect. Please verify, that the printer is assembled correctly,
that all axes move freely, the pulleys do not slip and the print nozzle is clean. If
everything looks good, re-run the X/Y calibration and verify with a sheet of paper
between the nozzle and the print bed that the print nozzle does not touch the print
bed during the calibration routine. If you feel a friction of the nozzle against the sheet
of paper and the nozzle is clean, you need to screw the PINDA probe slightly lower
and re-run the X/Y calibration.
2)
XYZ calibration failed. Please consult the manual.
The calibration points were found in positions far from what should be expected for a
properly assembled printer. Please follow the instructions of case 1).
3)
XYZ calibration ok. X/Y axes are perpendicular. Congratulations!
Congratulations, you built your printer precisely, your X/Y axes are perpendicular.
4)
XYZ calibration all right. X/Y axes are slightly skewed. Good job!
Good job, the X/Y axes are not precisely perpendicular, but still quite all right. The
firmware will correct for the X/Y skew during normal printing, so boxes will be printed
with right angles.
5)
XYZ calibration all right. A skew will be corrected automatically.
You may consider to re-align the X/Y axes (as described in the chapter
6.3.5.2 Y
axis alignment
)
. Still the firmware will correct the skew during normal printing and as
long as the X and Y axes move freely, the printer will print correctly.
6)
XYZ calibration failed. Left front calibration point not reachable.
Even if the printer moves the print bed to the end Y end stop, the PINDA probe
cannot reach the left front bed calibration point. Move the left Y threaded rod in the Z
frame away from you, so the PINDA probe reaches the left front bed calibration point
reliably.
You can find how to fix this in the next chapter
6.3.5.2 Y axis
alignment
.
7)
XYZ calibration failed. Right front calibration point not reachable.
Even if the printer moves the print bed to the end Y end stop, the PINDA probe
17
Summary of Contents for Original Prusa i3 MK2S 1.75mm
Page 1: ......
Page 25: ...Pict 11 Probe response diagram Now you are done 25 ...
Page 61: ...Pict 35 Nozzle change 61 ...
