2.0 Frame Assembly - Reprap Prusa Mendel Build Manual
©2012 NextDayReprap
Prusa Mendel Kit Build Manual V1.01 - 07/2012
Step 10
Take two 300mm threaded rods. Thread the Y Motor Bracket on to both rods as in the photo
below.
Then thread all of the following parts on the upper threaded rod (The upper rod is the one that
is closest to the longer flat edge on the Y Motor Bracket), from left to right. M8 Washer/M8
Nut/M8 Nut/M8 Washer/Bar Clamp/M8 Washer/M8 Nut/M8 Nut/Fender Washer/M8 Washer/
608 Bearing/M8 Washer/Fender Washer/M8 Nut/M8 Washer/Y Motor Bracket/M8 Washer/M8
Nut/M8 Nut/M8 Washer/Bar Clamp/M8 Washer/M8 Nut/M8 Nut/M8 Washer.
Then Thread the following parts on the lower threaded rod, from left to right. M8 Washer/M8
Nut/M8 Nut/M8 Washer/Y Motor Bracket/M8 Washer/M8 Nut/M8 Nut/M8 Washer. This
component should look like the photo below.