PRTC Digital TV Ser vice
Technical Support (843) 538-5481
www.PRTC.coop
PRTC Digital TV Ser vice
8
9
CONTROL UP TO FOUR DEVICES WITH YOUR REMOTE
At the time of your installation your remote was programmed to control your TV and Digital Receiver.
Your remote can also control up to two other devices like a DVD player, stereo receiver or home
theater system.
ASSIGN DEVICES TO THE MODE BUTTONS
1. Turn on the device you would like to program into your remote.
2. Aim the remote at the device, and press and hold the mode button you want to assign it to
(
,
,
).
3. Press
while holding the mode button, and then release them both. All mode buttons will
flash twice.
4. Enter
9 2 2
within 10 seconds using the number keypad on the remote. The mode button you
previously selected will flash.
5. Press
PLAY
if the device is a TV or DVD player. Then press
FF
repeatedly until the device turns off.
6. Press
PLAY
if you are setting up the
button. Then use the number keypad to enter one of
the following:
1
for VCR
2
for stereo receiver/tuner
3
for amplifier
4
for home theater in a box
7. Press
to save the settings.
8. Press the device’s mode button, and then press
POWER
.
The device should turn on. Refer to the
remote’s manual if it does not.
9. Repeat for any other devices.
Now you can operate multiple devices with one remote by using your mode buttons.
CONTROL THE VOLUME
At the time of your installation your remote was programmed to control your PRTC Digital Receiver
and your TV. This includes the
VOLUME
and
buttons.
To assign the volume controls to any other device follow the instructions below.
1. Press and hold the button. Press
while holding the button then release both. All mode
buttons will flash twice.
2. Enter
9 5 5
on the number keypad. The button will flash twice.
3. Press the mode button for or if you would like to send the volume control to a device
assigned to one of those buttons. The mode button will flash three times.
4. If you want
VOLUME
and
to control all devices depending on the active mode Press
.
The button will flash three times.
CONTROL CHANNEL SELECTION
Channel control buttons like and are programmed to affect your Digital Receiver. If you
would like to assign channel controls to any or all of the devices assigned to your remote, follow the
instructions below.
1. Press and hold the button. Press
while holding the button then release both. All mode
buttons will flash twice.
2. Enter
9 6 6
on the number keypad. The
button will flash twice.
3. Press the mode button for or if you would like to send channel controls to a device assigned
to one of those buttons. The mode button will flash three times.
4. If you want and to control all devices depending on the active mode press
. The
button will flash three times.
CONTROL POWER ON OTHER DEVICES
At the time of your installation the
POWER
button on your remote was programmed to affect
your Digital Receiver. If you would like to assign the
POWER
button to other devices, follow the
instructions below.
1. Press and hold the button. Press
while holding the button then release both. All mode
buttons will flash twice.
2. Enter
9 7 7
on the number keypad. The button will flash twice.
3. Press the button, it will flash twice. Press the button, it will also flash twice.
4. Press and / or to control those devices, each button will flash twice.
5. Press
once you are finished adding devices and then the button will flash three times.
