Proware DP-503-F4A3, Installation And User Manual

Page: 6 / 84

DP-503-F4A3 RAID SUBSYSTEM
6 Installation and User Manual
Before You Begin
Before going through with this manual, you should read and focus to the following safety
guidelines. Notes about the subsystem’s controller configuration and the product packaging and
delivery are also included.
Safety Guidelines
To provide reasonable protection against any harm on the part of the user and to obtain
maximum performance, user is advised to be aware of the following safety guidelines particularly
in handling hardware components:
Upon receiving of the product:
™
Place the product in its proper location.
™
To avoid unnecessary dropping out, make sure that somebody is around for immediate
assistance.
™
It should be handled with care to avoid dropping that may cause damage to the product.
Always use the correct lifting procedures.
Upon installing of the product:
™
Ambient temperature is very important for the installation site. It must not exceed 30
◦
C. Due
to seasonal climate changes; regulate the installation site temperature making it not to
exceed the allowed ambient temperature.
™
Before plugging-in any power cords, cables and connectors, make sure that the power
switches are turned off. Disconnect first any power connection if the power supply module is
being removed from the enclosure.
™
Outlets must be accessible to the equipment.
™
All external connections should be made using shielded cables and as much as possible
should not be performed by bare hand. Using anti-static hand gloves is recommended.
™
In installing each component, secure all the mounting screws and locks. Make sure that all
screws are fully tightened. Follow correctly all the listed procedures in this manual for reliable
performance.
Controller Configuration
This RAID subsystem supports single controller configuration.
Packaging, Shipment and Delivery
™
Before removing the subsystem from the shipping carton, you should visually inspect the
physical condition of the shipping carton.
™
Unpack the subsystem and verify that the contents of the shipping carton are all there and in
good condition.
™
Exterior damage to the shipping carton may indicate that the contents of the carton are
damaged.
If any damage is found, do not remove the components; contact the dealer where you purchased the
subsystem for further instructions.