EN
17
required minimum opening for the rectangular window
can be found in the table for tilt and swivel windows as
an example.
1. Determine the exhaust air capacity of your exhaust air
device in m
3
/h. You can find the exhaust air capacity
on the type plate or in the operating instructions for
your exhaust air device (e.g. extractor hood).
2. Measure the inside width and height of the window
and calculate the window size in m².
(Width x height = m²); e.g.
(0.8 m x 1.0 m = 0.8m²) = window size
3. Determine the opening size (minimum opening of your
window) from your exhaust air capacity and window
size using the table.
4. Measure the upper inside window opening gap in cm
when tilted. The gap size on your window may not be
less than the determined opening size! A larger gap or
window opening is advantageous.
5. If the gap size for the window is less than the
permitted value for the window opening in accordance
with the table, then the window may only be able to
achieve the necessary opening when opened on swivel.
A minimum gap size must also be achieved in the swivel
position. The window transmitter must be attached in
such a way that the minimum gap size is ensured. We
recommend fixing the minimum gap size with the help
of a distance piece.
CODING THE EXHAUST AIR CONTROL
The window transmitter
(6)
is not factory coded and
must be taught-in to the receiver during the initial
commissioning.
Please follow the order indicated precisely!
1. Plug the connector of the device to be connected (e.g.
extractor hood) into the RECEIVER, and mount the plug
guard
(S)
.
NOTE
The system cannot function without the plug guard
(S)
.
2. Then plug the RECEIVER into the network connector.
LED “NETWORK”
(3)
lights up green if the function of
the RECEIVER is in order.
3. At the RECEIVER keep the button
(2)
pressed down for
5 seconds until the green LED “ON”
(4)
and the red
LED “OFF”
(5)
flash alternately.
4. Insert the battery (CR 2477) in the window TRANSMITTER
(6)
. The LED on the transmitter lights up briefly.
5. Activate the window TRANSMITTER by holding the
magnet once on the housing and removing it again.
The LED integrated in the transmitter lights up. LED
“ON”
(4)
and LED “OFF”
(5)
stop flashing alternately
on the RECEIVER and the teach-in process is completed.
Summary of Contents for AS-5120
Page 1: ...AS 5120 BETRIEBSANLEITUNG 02 OPERATING INSTRUCTIONS 12 ...
Page 22: ...22 NOTES ...
Page 23: ...23 ...
