Protector AS-5120, Operating Instructions Manual

Page: 15 / 24

NOTE
Make sure that the battery of the transmitter is
placed on the metal tie bar and do not slide it
below this.
3. Press the housing upper section of the window transmitter
onto the housing lower section. (See Figure on Page)
4. Mount the housing lower section (8) at the intended
location with the enclosed adhesive pad.
ATTENTION!
The distance between the transmitter and magnet
must not exceed 7 mm and please ensure a firm
and correct fit of the individual components.
5. Insert magnet and close with the magnet housing upper
section (8) .
Minimum width of window opening
Before mounting you should determine the minimum
opening width of your window.
This is based on:
a) The performance of the exhaust air device in m³/h
b) The size of the window to be opened in m²
c) The size of the window opening in cm
(see table 1)
Most kitchens have rectangular tilt and swivel windows.
If you have windows that are, for example, round, then
please ask the installation technician, heating engineer
or electrician to calculate the minimum opening. The
ATTENTION!
Always check whether the power consumption of
the connected device is less than or equal to the
switching capacity.
Assembly instructions for window transmitter
Preparation
Mount the window transmitter (6) and magnet (8)
on the upper window frame and casement so that the
distance on all sides of the two housing parts is less
than 7 mm. Use the enclosed washers
(U) to make
adjustments for this.
1. Determine the intended location for the window
transmitter and magnet and clean adhesive areas.
Mount housing lower section of the window
transmitter
(6) at the intended location with the
enclosed double-sided adhesive pad.
Alternatively, a prepared hole is located in the housing
lower section, through which the window transmitter
can be screwed tight to the window frame. For this,
remove the board from the housing lower section
and screw the housing tight with the enclosed screw.
Replace the board after this.
2. Insert battery with correct polarity into the lower section
of the window transmitter (6) .
EN
15