Protector AS-5120, Operating Instructions Manual

Page: 18 / 24

6. 30 seconds after the last teach-in, the receiver
automatically quits teach-in mode.
7. The current status of the window transmitter (6) is
displayed after a correct teach-in process. And the
receiver responds to the activation of the window
transmitter. If this is not the case, please repeat
point 5 again.
8. The TRANSMITTER on the RECEIVER is now taught-in
and the AS-5120 is ready for use.
Teaching-in multiple transmitters
(max. 6 transmitters)
1. Press the button (2) on the receiver for 10 seconds.
2. Depending on the switching status, LED “ON” (4) or
LED “OFF” (5) no longer light up on the RECEIVER.
3. LED’s “ON” and “OFF” (4 and 5) are now dark and
the deletion was successful.
4. At the RECEIVER keep the button (2) pressed down for
5 seconds until the green LED “ON” (4) and red LED
“OFF” (5) flash alternately.
5. Insert the battery (CR 2477) in the window TRANSMITTER
(6) . The LED on the transmitter lights up briefly.
6. Activate the TRANSMITER by holding the magnet once
on the housing and removing it again or pressing the
Status button. The LED “NETWORK”
(3) stops flashing
on the RECEIVER and the teach-in process is completed.
7. Repeat steps 5) and 6) for each individual transmitter.
8. 30 seconds after the last teach-in, the receiver
automatically quits teach-in mode.
9. If max. 6 TRANSMITTERS are taught-in, no further
transmitters can be added.
Deleting all TRANSMITTERS
(Factory default)
1. Press the button (2) on the receiver for 10 seconds.
2. Depending on the switching status, LED “ON” (4) or
LED “OFF” (5) no longer light up on the RECEIVER.
3. LED’s “ON” and “OFF” (4 and 5) are now dark and
the deletion was successful.
EN
18