P. 22
Installation Guide
Installation-programmable Features
The following features can be programmed according to the needs of the installation and the
requirements of the user:
Ignition-Controlled Door Locks
1.
Ignition Lock disabled: turns OFF the Ignition Lock feature.
2.
Ignition Lock enabled: locks all Doors when the key is in the ON position and the user
presses the
Brake Pedal. Similarly, when the Ignition key is turned to the OFF
position, the Doors will unlock.
3.
Ignition Lock Only: the system will only lock all Doors when the Ignition Key is turned
to the IGNITION ON (RUN) position and Brake Pedal is pressed.
4.
Ignition Unlock Only: the system will unlock all Doors when the Key is turned to the
OFF position, provided the Ignition Key was in the IGNITION ON (RUN) position and the
Brake Pedal was pressed at least once.
Secure Lock
This feature allows the module to control certain OEM factory alarm systems without requiring the
use of other wires for disarming the OEM alarm. (Namely, this feature is designed for OEM
systems that use the factory lock wire to arm the alarm and the unlock wire to disarm it.)
1)
Standard Secure Lock disabled: By default, the unit will send a disarm pulse before IGN,
an arm pulse once the car is remote started and an arm pulse 4 sec after the engine shuts
down.
Note: No lock pulse or unlock pulse is sent at any moment of the remote start sequence.
2)
Standard Secure Lock: If this Option is selected,
at remote start, the module will send an
unlock/disarm pulse (disarming the factory Alarm)
before start-up, lock pulse when the
engine is running, and lock/arm pulse 4 seconds after the engine shuts down.
Note: The unit DOES NOT send an arm pulse while the engine is under remote start.
3)
Smart Secure Lock:
i)
If the vehicle was previously locked with the remote starter transmitter, at remote
start the module will send an unlock/disarm pulse before start-up, lock pulse when
the engine is running, and lock/arm pulse 4 seconds after it shuts down the
engine.
ii)
If the vehicle is initially unlocked, the unit will not send a lock pulse, arm pulse,
unlock pulse or a disarm pulse at any moment of the remote start sequence.
Note: The unit DOES NOT send an arm pulse while the engine is under remote start.
AUX 3 ouput
This 500 mA negative AUX 3 output (trunk output) can be used for many different applications. The
output can be programmed to give a 1-sec. or to give a continuous output as long as the button
is held down.
OPTION 1
Constant output: Pressing and holding the button for more than 5 seconds
will send a disarm pulse and a negative pulse to the trunk wire as long as the
button is held down (maximum of 15 sec.). A rearm pulse is sent after 30sec.
(passive mode).
OPTION 2
1-sec. trunk pulse: Pressing the
button for 5sec will send a disarm pulse, a
1sec negative trunk pulse and a rearm pulse after 30 sec. (passive arm).
