P. 16
Installation Guide
Manual or Automatic Transmission
This module may be installed on vehicles with manual or automatic transmissions. It is originally
configured for manual transmissions. If the vehicle you are working on is automatic, it is mandatory
to make a few quick and easy modifications before the unit is connected. In the event that the
configuration requires changes afterwards, a complete reset will be necessary before those
changes become effective.
To install this unit in a vehicle with a manual transmission:
1.
Make sure the Yellow loop on the PC board is connected.
2.
Connect the Orange handbrake wire located on the 12-pin harness to the vehicle
handbrake switch.
3.
Connect the Blue/White (+) door input OR the Grey (-) door input wire located on the
12-pin harness to the vehicle door pin wire, which monitors all the doors of the vehicle
(only use 1 of the 2 door trigger inputs).
4.
Make sure the Purple TACH wire is plugged in – the TACH wire MUST be hooked up
when the module is set for a manual transmission.
5.
Make all your regular connections.
6.
Power up the unit by first inserting the 5-pin connector, then the 6-pin connector and
finally the 12-pin connector. The parking lights will flash 4 times to confirm that the unit
is in manual mode.
7.
When learning the transmitter, the parking lights will flash 5 times quickly, confirming
that the module is set to manual mode.
8.
Upon the first successful remote start, the system will lock the transmission
settings to manual mode.
To install this unit in a vehicle with an automatic transmission:
1.
Cut the loop on the pc board (Yellow wire).
2.
Make sure the Orange handbrake wire is not connected to any of the vehicle circuits.
3.
Make all the regular connections.
4.
Power up the unit. The parking lights will flash 4 times.
5.
When learning the first transmitter, the parking lights will flash 5 times quickly.
6.
Upon the first successful remote start once the yellow loop has been cut, the
system will lock the transmission settings to automatic mode.
Note1: When learning the first transmitter after the unit is RESET, the parking lights will flash
5 times quickly followed by 2 slow flashes confirming that the module is set to automatic
mode.
Note2: If upon pressing the button, the parking lights give 3 slow flashes, make sure that
the Orange handbrake wire is not connected and that the yellow loop is cut and isolated.
Transmitter Programming Procedure
1.
Enter programming mode (page-17) - the parking lights will stay on for up to 20
seconds.
2.
Before the lights go out, turn the ignition key to the Ignition On (Run) position and
immediately to the OFF position.
