Installation Guide
P. 13
Wire
Description
5
WHITE /
GREEN
(–)
Disarm
output
500 mA ground output when the button is pressed. This wire is for
disarming OEM Alarm systems.
Note: System will also give a DISARM pulse before remote start.
6
BLUE /
WHITE
(+)
Positive
Door input
This input should be used in vehicles that use a positive-switching
Dome Light circuit. Connect to a Dome Light wire t12 V with a
Door open.
CAUTION! You can only use either the NEGATIVE DOOR INPUT or
the POSITIVE DOOR INPUT wire. It is essential that the Module be
connected in such a way as to allow each one of the Doors to be
detected by the remote starter.
7
WHITE /
ORANGE
(–)
Starter Kill
output
The unit is equipped with a selectable passive- or active-arming Starter
Kill circuit that will immobilize the vehicle when the system is armed.
This wire will provide a constant 500-mA negative output when the
system is armed (locked by remote) or if remote started. This wire
should be connected to a Single Pole Double-Throw Relay (This wire
will connect to Pin 85, on the Relay, and Pin 86 will be connected to the
Ignition wire).
A second benefit of the Starter Kill is the Anti-Grind feature. When the
vehicle has been remote started the Anti-Grind prevents the starter
motor from re-engaging when the ignition key is inserted in the Ignition
switch and accidentally turned to the CRANK position (The Starter Kill
output becomes active during remote starts).
8
ORANGE
(–) Parking
Brake
input
This input is for manual transmission vehicle ONLY. It is used in the
Ready Mode sequence and must be connected. The Parking Brake
input must be given a ground signal (-) when the Parking Brakes are
applied.
9
PURPLE
(+) Siren
output
+12 V Siren output. Connect to the positive side of the Siren.
10
WHITE (–)
Ground
out when
running
This wire provides a constant 500 mA negative output while the vehicle
is remote started. The output becomes active 1.5sec before Ignition,
and becomes inactive when the Module shuts down. The output can be
used to activate external relays, bypass kits, etc.
CAUTION! If multiple relays or modules are connected to the Ground
Out wire, ensure that they are all diode isolated in order to avoid
feedback and damaging the vehicle.
11
GRAY (–)
Negative
Door input
This input should be used in vehicles that use a negative-switching
Dome Light circuit. Connect to a wire that tests ground with a door
open.
CAUTION! You can only use either the NEGATIVE DOOR INPUT or
the POSITIVE DOOR INPUT wire. It is essential that the Module be
connected in such a way as to allow each one of the Doors to be
detected by the remote starter.
