Installation Guide
P. 17
3.
Press and hold the button and keep it down until the siren chirps twice.
4.
The transmitter has been stored in memory.
Note: Each unit can store 4 remotes in its memory. To program a transmitter on the
second vehicle for multi-car operation, you must press the button (instead of or
) in step 3 of the transmitter programming procedure:
Entering Programming Mode
This allows the installer to program the unit. Once the system is in programming mode, the installer
will have up to 20 seconds to select one of the sub-menus. If the installer fails to select a sub-menu
before the 20-second delay, the system will exit programming mode.
Using the Hood Pin
•
Press and hold the hood pin for 4 seconds.
•
Release the hood pin.
The parking lights will turn ON.
•
While the parking lights are ON, press the hood pin once more and
release immediately.
The parking lights will turn ON and stay ON for 20 seconds.
•
You now have 20 seconds to select one of the sub-menus.
Note: To exit programming mode, close the hood.
The Programming Assistance Button (a.k.a. PAB)
The PAB is located on the
side of the module. This
push button mimics the
hood-pin switch in order to
avoid having to get out of
the vehicle and pressing
the hood-pin switch. The
PAB will work only when
the hood is up.
Sub-menus:
a)
Transmitter Programming
b)
Programming Options
c)
Honk Horn/Siren Timing Adjustment
d)
Tach Programming