PROSPOTfitness Fusion SSG, Owner'S Manual

Page: 3 / 22

Assembly Instructions for the
SSG
Step #1 MAIN FRAME ASSEMBLY
1. Place the (#17, #151) Base Rails opposite each other in the center of the assembly area as
shown in the illustration #1. Place (#53) Bottom Cross Brace between the two Base Rails so
that the side, pre-drilled holes of the Base Rails align with the holes of the Lower Frame
Cross Brace. Feed (#55) & (162) Wire Harness’s thru left & right base rails (#17 & #151) up
thru square cut out in rail. Place (#52) Upright support plates on each of rails, lining up the
predrilled holes and secure with the lower four (#107) bolts, (#90) flat washers and (#91)
lock nuts.
2. Now place (#31right, #35 left) Locking Posts on top of Base Rails (#17, #151) and secure
with four (#107) bolts, (#90) flat washers and (#91) lock nuts. Be careful of wires do not
pinch between metal pieces. This may take two people to perform this task.
3. Next connect the (#55) Base Frame Wire Harness to the (#136) Locking post wire Harness.
4. Now place the (#24 & #26) Inside & Outside Connecting Plates at top of (#31, #35 ) Locking
Posts and slide four (#107) bolts, (#90) flat washers to hold Plates in position. Make sure
(#41, #57) Barbell Cables that have the (#58) Weight Bar Cable Knuckles are on the side of
the bolt closest to the front of the unit.
5. Now position (#12) Top Rail on to these bolts and secure with(#90) flat washers and
(#91)lock nuts. This may take two people to perform this task.
6. Now install (#27) Large Double Groove Pulley between (#24 & #26) Inside & Outside
Connecting Plates according to diagram #2. When installing make sure (#58) Weight Bar
Cable Knuckles connected to (#41, #57) Barbell Cables are placed over this pulley
according to diagram #3. Make sure cables are not twisted.
7. Now install (#30) Small Double Groove Pulley between (#24 & #26) Inside & Outside
Connecting Plates according to diagram #2. When installing make sure (#18, #54) Lower
Cable Knuckles connected to (#41, #57) Barbell Cables are placed over this pulley
according to diagram #3. Make sure cables are not twisted.
8. Now bolt (#18,#54) Lower Cable Knuckles connected to (#41,#57) Barbell Cables to (#17,
#151) Base Rails using (#99) Bolt, (#100) Spacers, (#90 Flat Washers and (#91) Lock nuts.
Make sure cables are not twisted. Note: (#18, #54) Lower Cable Knuckles should be facing
(#31 right, #35 left) front toward Locking Posts.
9. Next connect (#136) Locking post wire Harness plug into (#18, #54) Lower Cable Knuckles.
10. Now place and install according to diagram #2, (#28, #58) left & right Selector Plates and
secure with four (#107) bolts, (#90) flat washers and (#91) lock nuts. Note: Openings in
Selector Plates should face downward.
STEP #2 – FRONT UPRIGHT INSTALATION
1. Now install (#15, #51) right & left Folding Uprights into (#28, #58) left & right Selector Plates
and onto stud on (#17,#151) Base Rails. Make sure brass bushings on stud are on top of
Upright’s bottom plate. Secure Base Rail stud with (#90) flat washers and (#91) lock nuts.
Now bolt upper pivot points at bottom of (#28, #58) left & right Selector Plates with (#104)
bolts & (#90) flat washers.
Page 3