PROSPOTfitness Fusion SSG, Owner'S Manual, Page: 2 / 22

To Get Started:
Before assembly, choose a safe location for your
Prospot Fitness®
SSG.
•
The
SSG
has a footprint of approximately 6’x 6’. The barbell is approximately 7’ long. Locate
your
SSG
away from any source of water. Do not allow any liquid to be near the machine or
spilled on any electrical part. Do not insert any object into the electrical box.
•
Approximate assembly time is 1-1/2 – 2 hours.
•
A flat area of 9’ x 9’ will be required to assemble and properly use the
SSG
.
•
You will need the following tools and a helper to complete the assembly:
•
17 mm, 19mm Hex Head Wrench or Adjustable wrench.
•
Metric Ratchet set
•
4 mm Allen Wrench
•
5 mm Allen Wrench
•
Philips Screw Driver
•
Scissors
•
Razor knife
•
Floor Padding, such as cardboard, to avoid scratching your floor during assembly.
•
HAND TIGHTEN all bolts. DO NOT fully tighten bolts until instructed to do so.
•
Assistance by a second person is recommended for some steps of this assembly.
•
The
SSG
uses several different lengths of bolts. Be careful to use the correct length of bolt
called for at each step of assembly. Bolt packs are label with part # and descriptions.
ALWAYS REMEMBER:
After the initial set up of the system or after
performing any service on the unit, RESET the Computer on your ProSpot system
before using it. Just unplug the power supply from the Electronic Box, wait 30
seconds and plug back in. Resetting the Computer allows it to recalibrate and work
to its greatest efficiency.
Page 2