MVI56-BDW
♦
ControlLogix Platform
Diagnostics and Troubleshooting
BARDAC Drive Web Interface
Page 46 of 82
ProSoft Technology, Inc.
September 4, 2008
Resetting diagnostic data
Press
[U]
to reset the status counters for the client and/or servers in the module.
Viewing Version Information
Press
[V]
to view Version information for the module.
Use this command to view the current version of the software for the module, as
well as other important values. You may be asked to provide this information
when calling for technical support on the product.
Values at the bottom of the display are important in determining module
operation. The Program Scan Counter value is incremented each time a
module's program cycle is complete.
Tip: Repeat this command at one-second intervals to determine the frequency of program
execution.
Warm Booting the Module
Caution: Some of the commands available to you from this menu are designed for advanced
debugging and system testing only, and can cause the module to stop communicating with the
processor or with other devices, resulting in potential data loss or other failures. Only use these
commands if you are specifically directed to do so by ProSoft Technology Technical Support staff.
Some of these command keys are not listed on the menu, but are active nevertheless. Please be
careful when pressing keys so that you do not accidentally execute an unwanted command.
Press
[W]
from the Main Menu to warm boot (restart) the module. This command
will cause the program to exit and reload, refreshing configuration parameters
that must be set on program initialization. Only use this command if you must
force the module to re-boot.
Viewing Client Status
Press
[1], [2], [3]
or
[4]
to display the statistics of clients 1 through 4,
respectively.
Viewing Client Configuration
Press
[5]
to display the configuration information for the client.
Opening the Network Menu
Press
[@]
to open the network menu. The network menu allows you to send,
receive and view the WATTCP.CFG file that contains the IP, gateway and other
network specification information. You can find more information about the
commands on this menu in the Network Menu (page 51) section.
