8844151
100 pc Air Tool Kit
V1.0
10
For technical questions call 1-800-665-8685
SOCKETS
INCH
METRIC
3/8 in. Drive
5/16 and 3/8 in.
8 and 9 mm
1/2 in. Drive
7/16, 1/2, 9/16 and 5/8 in.
10, 12, 13 and 15 mm
SCREW BITS
INCH OR UNIT
METRIC
Hex
1/8, 5/32, 3/16, 7/32 and 1/4 in.
4 and 5 mm
Slotted
3/16, 1/4 and 1/8 in
Torx®
10, 15, 20, 25, 27, 30 and 40
Phillips (cross)
PH1, PH2, PH2, PH2 and PH3
Robertson (square) S1, S2 and S3
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
INSTALL AIR COUPLER PLUG
Prepare a standard 1/4 in. NPT coupler plug (sold separately) for use
with your tool. There is one for each tool.
1. Wrap the external threads of the coupler plug with sealant tape.
1.1 Wrap tape in a clockwise direction so it will not unravel.
1.2 Do not tape all the threads. Leave several leading threads
unwrapped for easier alignment.
2. Screw the coupler plug into the tool's air inlet and tighten with a
wrench until snug.
3. Run the compressor at a low volume and check the connection for
air leaks. Do not use the tool until all air leaks are repaired or the
faulty component is replaced.
IMPORTANT! Vibration may cause failure if a quick coupler is
connected directly to the air tool. To overcome this, connect a
leader hose to the tool. A quick coupler may then be used to
connect the leader hose to the air hose.
