8844151
100 pc Air Tool Kit
V1.0
20
For technical questions call 1-800-665-8685
ASSEMBLY & INSTALLATION
SOCKET INSTALLATION
WARNING! The torque of the air ratchet is 50 ft-lb. Make sure that
the nut or bolt you are using the tool to tighten can withstand the
rated torque and is rated for 160 RPM or greater. If available,
check the recommended torque specifications for the nut.
1. Turn off the air compressor and disconnect the air hose when
changing sockets.
2. Select the appropriately sized 1/2 in. or 3/8 in. drive impact socket
for the job. Only use impact sockets which are specifically designed
for use with an air ratchet. Do not use worn or damaged sockets.
2.1 Use the 3/8 in. to 1/2 in. adapter when using 1/2 in. sockets.
3. Push and snap the socket (not included) onto the anvil (#AR24).
4. Attach the air hose and turn the air compressor on.
OPERATION
WARNING! This tool generates considerable torque when in use.
Always hold the tool with both hands when using and brace yourself
to resist the torque which will be delivered to the workpiece.
1. Tighten the nut as far as you can by hand before using the air ratchet.
2. Connect the air ratchet to the air hose.
3. Turn the forward/reverse switch (#AR26) to the left for forward or
right for reverse.
3.1 Wait until the tool’s anvil has stopped rotating before switching
to the opposite direction.
4. Place the socket over the fastener, grip the air ratchet firmly and
gently squeeze the trigger. The air ratchet will activate when the
trigger is squeezed.
4.1 If the tool stalls while tightening, do not raise the output
pressure of the air compressor above 90 PSI. Pressure above
90 PSI will strip the workpiece and damage the tool,
potentially causing tool failure and serious injury. Use other
appropriate methods and tools to tighten the nut.
