PRONAR ZEFIR 85, Servicing Instruction

Page: 20 / 88

PRONAR
D. CONTROL AND CHECK ELEMENTS
PRONAR
10
CAB
Before starting work with the tractor you must get acquianted with appropriation of
control organs, indicators and their indications. Information contained in the
Instruction will help you to drive the tractor correctly and safely to perform, by means
of this tractor, planned works with possibly the least effort.
The cab has been designer so as to ensure
appropriate comfort and convenience to the operator.
The standard equipping of the cab is composed of the
heating and ventillation system of the cab, sun visor,
windscreen wiper with washer, rear window wiper, half-
open side and rear windows, half-open flap of the roof
and externally regulated rear-view mirrors.
You can go into the cab from the left side and the
right side. However it is recommended to enter from the
left side with regard to levers of the driving system
located on the right side of the seat. They may hinder
entering from the right side of the cab.
Fig. D-1a The cab of tractors ZEFIR type P8
In order to get into the cab you must stand in front of the doors and open it by means of external
handle equipped with the lock closed by means of key. Next catching hold of the hand-rail situated outside
the cab on the left side and the hand-rail on internal part of the door on the right side you must climb the anti-
slip foot-plates and go into the cab. Close the door after entering and sit down on the operator’s sit.
ATTENTION: In order to prevent falls when entering and going out from the tractor you must use
hand-rails and foot-plates. Remove mud, snow, ice and pollutions.
Going out from the cab you must open the door, catch the hand-rails and being with own back turned
outside of the cab, go down the foot-plates holding the hand-rails.
1
The right and left of the cab are equipped with handles with lock which allow
to close the cab from outside by means of key. I order to open the closed
door you must turn the key and next push inwards the lock
1 being in the
handle.
Fig. D-1b External handle of the door
1
2
3
In order to open the door from inside you must pull the lever 1 releasing the
mechanism of the door lock. The lever 2 serves for interlocking of the door
lock and protecting against accidental opening the door.
After opening we may leave the door in fully opened position kept thanks to
gas spring or kept in slightly half-open position thanks to special lever
located at the cab frame which must be deviated so that it will possible to
snap the door lock on the cab frame.
Fig. D-1c Internal handle of the door