En 11 / 56
Fig. 7-2
Fig. 7-3
7-9.REMOVING AND INSTALLING THE BLADE
When it is necessary to replace the blade,
proceed as follows:
1. Raise the saw frame about 6" and close the
feed on/off knob by turning it clockwise as far as
it will go (fig 8).
2. Move the blade guide arm to the right.(Fig.9).
3. Disconnect the machine from the power source.
Loosen cover screw, remove cover (A), open
the cover (B), remove cover (C) , then clean the
chips and dirt inside the machine.
4. Release blade tension (F) (fig 9) by turning the
blade tension hand-wheel counterclockwise.
5. Remove the blade from both wheels and out of
each blade guide. But remove side (B) saw
blade. When totally released, then remove the
side (A).
6. Make sure the teeth of the new blade are
pointing in the right direction. IF necessary, turn
the blade inside out.
7. Place the new blade on the wheels. In the blade
guides and adjust blade tension and blade
guides.
Fig.8
Fig.9
8.MAINTAINING
That's easier to keep machine in good condition or
best performance by means of maintaining it at any
time than remedy it after it is out of order.
(1) Daily Maintenance (by operator)
(a) Fill the lubricant before starting machine
everyday.
Summary of Contents for SX-824DG
Page 49: ...47 56...
