En 12 / 56
(b) If the temperature of spindle caused
over-heating or strange noise, stop machine
immediately to cheek it for keeping accurate
performance.
(c) Keep work area clean; release vise, cutter,
work-piece from table; switch off power
source; take chip or dust away from machine
and follow instructions lubrication or coating
rust proof oil before leaving.
(2) Weekly Maintenance
(a) Clean and coat the cross leading screw with
oil.
(b) Check to see if sliding surface and turning
parts lack of lubricant. If tile lubricant is
insufficient, fill it.
(3) Monthly Maintenance
(a) Check if the fixed portion has been loose.
(b) Lubricate bearing worm, and worm shaft to
avoid the wearing.
(4) Yearly Maintenance
(a) Adjust table to horizontal position for
maintenance of accuracy.
(b) Check electric cord, plugs, switch, at least
once and a year to avoid loosening or
wearing.
9.Cooling system
This machine service cooling system .
The tube was separate. You need to connect it .
1. Assemble the machine stand
2. Assemble the chip-tank (A) ( Fig 10 )
3. Put the water tank (A) ( Fig 10-1 ) into the
machine stand
4. Connect the tube( B) ( Fig 10-1 ) from the
chip-tank (A) ( Fig 10 ) to the water tank
5. Screw tight of the tube at the down part of chip
tank by the screw( B) ( Fig 10-2 )
Fig.10-1 Fig.10-2
9-1 .Chips clean
That is easier to clean the chips by moving the
chips tank A ( Fig 10 )
Fig.10
Summary of Contents for SX-824DG
Page 49: ...47 56...
