Promac SX-824DG, Manual

Page: 38 / 58

En 4 / 56
2.SPECIFICATION
MOTOR 1.2HP 400V/50Hz
Saw Blade Speed
MPM 35~70
(50Hz)
Blade Size (mm) 27x0.9x2730mm
Dimension LxWxH (mm) 1900X715X1800
mm
N.W / G.W
(kgs)
310 / 340
Packing
Measurement 1580x770x1060mm
○ (mm) 240
0°
□ (mm) 240
○ (mm) 200
+ 45°
□ (mm) 200
○ (mm) 125
+60°
□ (mm) 125
○ (mm) 160
Cutting
Capacity
+ 45°
□ (mm) 150
3.FEARTURES:
1. This machine is useful for cutting normal steel,
steel pipe, and provides cutting angle at +
60°and +45°by the swivel head.
2. A tooth selection chart was provided on the
machine for cutting reference.
3. Variable speed control gives convenient
selection of speeds. (This machine comes with
a standard 2-speed motor. But can be
purchased with a DC driven motor as an
option.)
4. This machine is using manual cutting by pulling
down the saw bow by hand. Start(press) button
is located at the handle of the saw bow. Motor
stops when button was released.
5. Stability of the machine, plus working table
height is 950 mm, conforming to human
engineering.
6. The one-inch blade and carbide guide provide
better result of the cutting surface and
efficiency.
7. The one-piece casting and one time CNC
processing provide better rigidity and precision
of the machine.
8. The one-piece and full coverage blade cover
conforms to CE stipulation. Well coolant fluid
collection system provides clean and dry, and
safety of the working area.
9. Chip pan underneath the working table
prevents coolant fluid leaking and keep floor
dry.
10. Coolant for cutting,, water : oil = 40 : 1 oil
specification.
4.TRANSPORTATATION & INSTALLATION:
4-1.Unpacking
1. Transportation to desired location before
unpacking, please use-lifting jack. (Fig. B)
2. Transportation after unpacking, please use
heavy duty fiber belt to lift up the machine.
Fig, B
ALLWAYS KEEP PROPER FOOTING &
BALANCE WHILE MOVING
THIS MACHINE.
4-2.TRANSPORTATION OF MACHINE:
As this machine weights 208kgs(458.6lbs) it is
recommended that the machine be transported
with help of lifting jack.
Transportation Recommendation:
1.
Tighten
all locks before operation.
2. Always keep proper footing & balance while
moving this machine, and only use a heavy duty
of fiber belt to lift the machine as per Fig. A.
3.
TURN OFF
the power before wiring & be sure
machine is properly grounded.
Overload & circuit breaker are recommended
for safety wiring.
4.
Tighten
4 bolts to base holes after machine is
balanced.
5. Check carefully if the saw blade is running in
counterclockwise direction if not, reverse the
wiring per circuit diagram, then repeat the
running test.
6. Keep machine always out from sun, dust, wet,
or raining area.