Progressive Turf Equipment TD65, Operators Manual And Parts Lists

Page: 39 / 70

TD65
Operator’s Manual
37
SPINDLE SERVICE
Each spindle is supported by two ball bearings. No adjustment of
clearance is required. Running clearance is pre-set during
assembly by
tightening the 1” NF left hand
nut on top of the pulley.
Periodically inspect blade spindles by grasping pulley, and moving
from side to side. If any free play is noted, replace or repair.
SPINDLE ASSEMBLY REMOVAL
1) Relieve tension from belt, and remove belt from the spindle
pulley.
2) Raise the mower decks into the service position and ensure
the deck safety locks are secure
3) Remove blade from spindle.
4) From under the deck, loosen the four bolts that hold the
spindle assembly to the deck.
5) Remove the complete spindle assembly and pulley out
through the hole in the deck.
SPINDLE ASSEMBLY INSTALLATION
Reverse above procedure. Be sure spindle mounting area of deck
is clean of any foreign material before attaching spindle assembly.