Progressive Turf Equipment TD65, Operators Manual And Parts Lists

Page: 37 / 70

TD65
Operator’s Manual
35
BLADE SERVICING
Always observe proper lock-out procedures when performing
any maintenance work including changing or servicing the
blades. Always remove and retain the ignition switch key,
ensure parking brake is engaged, and block and or support
machine using equipment designed for the task.
Be sure deck and deck safety locks are engaged when working
on decks in the raised position.
Use gloves when handling mower blades. Blades can be very
sharp.
Inspect blades before each use to determine that they are mounted
tightly and are in good condition. Replace any blade that is bent,
excessively nicked, worn or has any other damage. Small nicks
can be ground out when sharpening.
Use only original equipment blades when replacing worn out
mower blades. They are made of special steel alloys and
subjected to rigid heat-treat and inspection requirements.
Substitute blades may not meet these specifications and MAY
BE DANGEROUS.
BLADE REMOVAL AND INSTALLATION
A 1” diameter pilot centers the blade on the spindle with two 1/2”
grade 5 fasteners. When changing blades, be sure that pilot is
properly seated in the blade and the blade lies flat on the spindle
bar.
Always replace bolts, lock washers and nuts when replacing
blades. Tighten bolts to proper torque as listed on Page 34.
Replace any blade that is bent, nicked dee
per than ¼”, excessively
worn or has any other damage. Small nicks can be ground out
during sharpening. Always balance blades before use.
In abrasive soil conditions, monitor condition of the blade wing. If
erosion
Eroded
Area
Deep
Nick