Mototronik 26
12.8 EBS (Electronic Brake System)
This feature slows down the MOTOTRONIK device by electrically reducing its speed. During EBS braking, the energy produced will be recovered and used to recharge the
battery. When the lightning symbol appears next to the battery symbol on the display, it means that the battery receives the charge.
Press the red button to activate the EBS.
The EBS is also activated when using the mechanical brake.
For the Standard handlebar, when pressing the brake lever, the first short section only drives the EBS while, beyond this point, the disc brake is operated.
For the Tetra handlebar, the first short stretch of the forward thrust of the handlebar (braking action) only drives the EBS while, beyond this point, the disc brake is operated.
In both cases, the two brakes combine. The intensity of the EBS is adjustable, see chapter 13.
12.9 Cruise Control
The Cruise Control function adapts and allows you to maintain a fixed speed while driving.
Press the green button to activate this function that will make the MOTOTRONIK device proceed at the speed detected at the time of activation.
The Cruise Control function can be deactivated by one of the following modes: 1) by operating the Standard handlebar brake lever or by pushing the Tetra handlebar forward (braking action);
2) by operating the EBS electronic brake (red button).
When using the cruise control function, it is mandatory to pay the utmost
attention to road hazards in order to be able to intervene promptly on the control
so as to avoid any type of collision that may cause damage to persons and/or
property.
The Cruise Control function does NOT deactivate if you press the green button
again, neither if you engage the reverse gear, nor if you press the acceleration
lever.
Do not start or use the cruise control function on uphill slopes greater than 10%
(6°), nor on downhill slopes greater than 5% (3°) (or lower according to the
surface condition).
Although the cruise control adapts the speed, there may be a slight difference
between the set speed and the actual speed when descending a slope. We
recommend setting a lower speed when going downhill.
12.10 USB port to charge your mobile phone
It allows you to charge your mobile phone by plugging it in with its own cable.
You can find the USB in the on/off and control switch. Flip the rubber cover up and
plug the cable into the port.
Press the "
M
" button once to activate the USB port. The USB symbol
will appear on the display when the port is active. (If the symbol does
not appear, press the "
M
" button again. By pressing this button, you can
also activate the headlight). The device will now start to charge the
mobile phone.
When the recharge function is no longer necessary, press the "
M
"
button to deactivate the USB port. The USB symbol will disappear, and
the port has been deactivated.
After charging, disconnect the cable and close the rubber cover.
M
