Mototronik 17
11.1 Coupling the connection frame
Make sure that the two lock levers
A
are unscrewed so that the room between the washer
B
and the half-moon-shaped block
C
is about 1 cm (or a little wider) to allow the passage of the coupling forks
D
.
If the levers, when unscrewing them, come off or if they have previously been removed, insert them, and screw them until they leave a space of 1 cm.
Grasp the connection frame
E
with one hand or two hands and keep it balanced horizontally with respect to the ground.
Align the two coupling forks to the half-moon-shaped blocks, insert them and slide them all the way.
Screw the lock levers making sure the washers perfectly fit the round housings
F
in the coupling forks. Finally, firmly tighten the two lock levers.
For greater safety, during each session of use of the MOTOTRONIK, check the fixing of the levers A. In fact, if the levers A were loosened, the system could even suddenly detach from
the wheelchair. Failure to comply with this warning may cause serious damage or injury for which Rehateam s.r.l. cannot be held responsible.
D
A
A
B
C
E
≈1 cm
F
