ProFlow Water softener, Installation & Operating Instruction, Page: 15 / 104

ELECTRONIC CONTROL PANEL
Page 15
EN - English
DUPLEX ECO ALTERNATING :

Each of the 2 Simplex system must be programmed
individually; the program does NOT necessarily have to be
the same on both Simplex systems, that make up a Duplex
system!
1. Press the down

button and hold it for 5 sec until the
display shows:
2.
Within 10 sec, press the buttons in the following
sequence:
down  - down  - scroll  - down  ; the
display will show:

Press the up

or down

button to set the volume
of softened water between regenerations , for the
Master system; this must be calculated, by dividing
the nominal exchange capacity of the system (see
Technical Data) by the water hardness.
3.
Press the scroll

button again; the display will show:

Press the up

or down

button to set the volume
of softened water between regenerations , for the
Slave system; this must be calculated, by dividing the
nominal exchange capacity of the system (see
Technical Data) by the water hardness.
4.
Press the scroll

button again; the display will show:
!!! Please disregard this function !!!
5.
Press the scroll  button again; the display will show:

Press the up  or down  button to set the number
of days between regenerations , for the Master
system.
6.
Press the scroll  button again; the display will show:

Press the up  or down  button to set the number
of days between regenerations , for the Slave system.
7. Press the scroll  button again; the display will show:

Press the up  or down  button to set the length
of the regeneration cycle , for the Master system.

Press the scroll

button again to advance to the
next regeneration cycle.
1Cycle 1 Backwash
1Cycle 2 Brine draw/slow rinse
1Cycle 3 Fast rinse/refill
8.
Press the scroll  button again; the display will show:

Press the up  or down  button to set the length
of the regeneration cycle , for the Slave system.

Press the scroll

button again to advance to the
next regeneration cycle.
2Cycle 1 Backwash
2Cycle 2 Brine draw/slow rinse
2Cycle 3 Fast rinse/refill
9.
Press the scroll

button again; the display will show:

Press the up  or down  button to set the type of
water meter sensor .
10.
Press the scroll  button again; the display will show:

Press the up  or down  button to save the
program into the NOVRAM® and exit the
programming level.
1Cycle 1: XX min
System Check
Capacit1: 10 00L
ExCap: 5.5 °f M3/L
Reset Average: NO
days
Regen:Immediate
Capacit2: 10 00L
Exit
Override1: 7 days
Override2: 7 days
2Cycle 1: XX min
MTR: SNAP SENSOR