ProFlow Water softener, Installation & Operating Instruction, Page: 13 / 104

ELECTRONIC CONTROL PANEL
Page 13
EN - English
PROGRAMMING INSTRUCTIONS -
PARAMETER SET LEVEL

Before entering the programming mode, make sure
that the control valve is in the service mode.

All configuration parameters on this water softener
have been pre-programmed in the factory, to offer optimal
performance in a wide range of applications and situations.
Nevertheless it may be necessary or desirable to change
any of these parameters, to further optimize the water
softeners performance or to adapt it to the specific
requirements of the installation.
SIMPLEX TEMPO :
1. Press the scroll  button and hold it for 5 sec until the
display shows:
2.
Within 10 sec, press the up

button; the display will
show:

Press the up  or down  button to set the length
of the regeneration cycle .

Press the scroll  button again to advance to the
next regeneration cycle.
Cycle 1 Backwash
Cycle 2 Brine draw/slow rinse
Cycle 3 Fast rinse/refill
3.
Press the scroll  button again; the display will show:

Press the up  or down  button to set the time of
regeneration .
4. Press the scroll

button again; the display will show:

Press the up  or down  button to save the
program into the NOVRAM® and exit the
programming level.
Cycle 1: XX min
System Check
Regen @ 2:00
Exit