Prodys PortaNet, User Manual

Page: 35 / 156

PortaNet User Manual 35 of 156
C O N F P O R T S M E N U
{ L A N } I S D N R S 2 3 2
L A N C O N F I G
{ I P } D H C P E T H P O R T S
L 1 : I D L E ( 0 ) I S D N
L 2 : I D L E ( 0 )
d.
SPID
When you are using NAT1 or DMS100 you must enter the correct
Service Profile ID (SPID) numbers for the ISDN BRI circuit.
e.
ANS
Automatic or manual response: When automatic response is
selected, the unit will connect automatically to an incoming call, always
doing so when there is no restriction imposed by the local number or
other such call filters. In manual mode, the incoming calls are indicated
on-screen and the user simply presses the corresponding CALL key to go
ahead and connect that line.
VII.4.2 Configuring the LAN port
Before making a connection over any IP network it is necessary to configure the
IP addressing parameters: IP address, netmask and gateway. PortaNet allows
the assignment of the IP parameters either manually or by DHCP.
Manually User must enter the following IP parameters manually:
1. IP address.
2. Mask.
3. Gateway IP address
Automatically The unit gets the configuration automatically from a
DHCP Server when starting.
VII.5 Checking the communication interfaces
Once the interface has been properly configured, the user can make some tests
to confirm that the unit is ready to work. An easy way to check that everything is
working fine is to make a ‘loop’ call, by calling our own unit.
VII.6 Connecting PortaNet to the line
Either using ISDN or IP, when plugging the link line cable into the unit, the
display should indicate this with the word “IDLE” on the screen.