ProCurve 10ag, Installation And Configuration Manual, Page: 85 / 132

6-7
Troubleshooting
Restoring Factory Default Configuration
You can restore factory default configuration either by pressing the Reset to
Default button on the rear panel, or by clicking the
Erase button on the Back
Up Settings page.
To restore to factory default using the Reset to Default button:
1. Using a pointed object such as the tip of a ballpoint pen or a straightened
clip, press the Reset to Default button for more than five seconds. The
LEDs flash rapidly (about 10 times per second).
2. As soon as the LEDs (except the Power LED) shut off, release the Reset
to Default button.
The access point resets to factory defaults and reboots.
To restore to factory default from the Web interface:
1. Log on to the Web interface.
2. On the menu, click Back Up Settings . The Back Up Settings page
appears.
3. Under Revert to Factory Default Settings, click Erase . The following
confirmation message appears:
Loading the Factory Default Settings will erase all the current settings.
4. Click OK to continue.
The following message appears:
Please wait....
Access Point is rebooting......
PLEASE WAIT until re-directed to Information page.
When the access point has completed restoring its settings to factory default,
the Web interface refreshes and displays the Information page. If the access
point was using an IP address other than the default, you may see a Page Not
Found message in your browser. This is because the access point has already
reverted to its default IP address,
192.168.1.14
, which may be incompatible with
your current network settings.