ProCurve 10ag, Installation And Configuration Manual, Page: 31 / 132

2-11
Installing the Access Point
Installation Procedures
Step 4. Position the Access Point
Unplug the access point from its power source, and then place it in the
network location that you have chosen. The access point can be installed on
a flat surface (for example, on a desktop) or wall-mounted (mounting kit is
not included). When deciding where to position the access point, choose a
location that:
■ Allows easy viewing of the front panel LED indicator lights, and access to
the rear panel connectors, if necessary.
■ Is centrally located to the wireless computers that will connect to the
access point. A good location will optimize wireless connections to
computers in both horizontal and vertical directions, allowing wider
coverage.
When positioning the access point, ensure:
■ It is out of direct sunlight and away from sources of heat.
■ Cabling is away from power lines, fluorescent lighting fixtures, and
sources of electrical noise such as radios, transmitters and broadband
amplifiers.
■ There are no thick walls or metal shielding between the access point and
the wireless clients and devices. In ideal conditions, the access point has
a range of approximately 100 meters. If there are any obstructions
between the wireless devices, the range is reduced and transmission
speed is lower.
■ Water or moisture cannot enter the case of the unit.
■ Airflow around the unit and through the vents on the side of the case is
not restricted. The access point should have a minimum of 25 mm (1 in.)
clearance.
Step 5. Connect the Access Point to a Power Source
1. Plug the included power adapter into the access point’s power connector
and into a nearby AC power source.
Alternatively, connect the Ethernet port on the access point to a switch
or other network device that provides Power over Ethernet.
N o t e
If you connect the access point to an AC power source and a PoE power source
at the same time, PoE will be disabled automatically.
2. Re-check the LEDs during the system initialization. See “LED Behavior”
on page 2-10 .