»
installation instructions
/ octo + Pro
60
Note the distribution of the various modules
constituting the coping on the drawing.
Arrange them on the coping support brackets
taking care to orient them with the finely
grooved surface facing upwards. Make sure
that the elements are correctly and evenly
positioned around the entire periphery of
the pool. Adjust them if necessary. The
cross section illustration, 60, shows correct
positioning of the coping module with respect
to the liner locking track.
Composite wood coping comes with junction
strips, leave a gap of approximately 8mm
between neighbouring coping modules to
accommodate fitting of these finishing strips.
It may be necessary to twist the strips slightly
in order to clip them into position. (refer to
the images 62 and 63).
The coping is 28.5cm wide.
Check the symmetry of the coping modules
and make corrections if necessary. Working
from underneath, attach the coping modules
to the anchoring plates on the coping support
brackets using hinge screws (bag G). Pre-drill
the holes before inserting the screws.
>>
FITTING THE COPING
58
59
60
