»
installation instruction
/ octo + Pro
55
>>
HYDRAULIC CONNECTIONS
Once all the connections have been made, continue filling the pool until the water level is 5 cm
below the return fittings or underwater lights (whichever is lower), then cut out the liner as
described on page 56 and finalise installation of the underwater lights (page 57 and underwater
light installation instructions).
Before continuing to fill the pool, check that all the valves are closed.
Connect tubes between the various pool fittings and the filtration group according to the diagram below. The
filtration kit supplied with your pool is sized for installation of the filtration group at a distance of 3.5 m from the
pool, hence the tube lengths are merely indicative. They will need to be modified to suit your installation. Take
care to calculate and cut lengths taking the total lengths of various coils of tubes supplied into consideration.
48
suction
return
1
2
3
4
1 = return
length = +/- 3,6 m
2 = return Y
length = +/- 0,85 m x2
3 = skimmer length = +/- 3,4 m
4 = vacuum point length = +/- 5 m
5 = Wall drain
length = +/- 4,3 m
5
PReCAUTIONS AND ADVICe:
When screwing the connections onto the unions (isolation valve), hand tighten only. Over tightening could damage the
union threading or twist the o-rings thus causing leaks.
Wrap Teflon 3 or 4 times around those connections not fitted with o-rings.
CONTINUe WITH FILLING
