»
installation instruction
/ octo + Pro
57
Open the various valves to fill the circuit with water. Check the various connection points for leaks.
Make sure that the pump is filled with water before starting it up. The pump should under no circumstances be allowed
to run dry. If necessary, open the pump and fill it and the line coming from the skimmer with water to facilitate priming.
Turn the 6-way valve to Backwash (to carry out a filter backwash before putting the filter into service). See page 56 & 59
for further information.
Start the pump and check again for leaks.
CHARGING THe CIRCUIT WITH WATeR
TiP:
In the case of an in-ground installation, check for leaks before burying the pipes and connections.
Finish installing the underwater lights
referring to the installation instructions
provided with said. Underwater lights should
be connected to the control panel provided.
The control panel should be installed in
accordance with the instructions provided.
Do not hesitate to contact a professional.
Screw the multi- directional eyeball assembly into the return fitting
body. The eyeball should be pointed left to facilitate the flow of water
necessary for efficient filtration.
(Prior to assembly, apply a layer of silicon grease to the eyeball and
its housing to facilitate its movement and subsequent removal for
Winterizing).
Screw the vacuum fitting plus into position.
56
Cut away the liner inside the flange. Keep the
off-cuts for future repairs.
Clip the weir into place, smooth surface facing
the pool. The weir should be able to swing freely.
Mount the skimmer face plate.
The skimmer basket is passed through the
skimmer mouth, swing the weir towards the pool to
make space.
Place the lid on the skimmer.
(these parts can be found in the Pool Fitting skin
pack)
55
57
>>
LINER CUT OUTS & UNDERWATER LIGHTS
Continue filling the pool until the water level is 2/3 of the way up the skimmer mouth.
