METIS Vision MV05
/ MV09 Rugged Thermovision Camera
25
7.3.2.1
Startup of camera /driver components
Please connect the camera to the power supply and directly or indirectly to the network cable with the evalu-
ating computer.
There are several little steps needed so that the
software can communicate with the camera. First
you have to start the software
Common Vision
Blox Management Console
which you can find in
the startup menue under
Stemmer Imaging-
>Common Vision Blox
t. The image shown on the
left will some up.
Please choose Gener
al settings and deactivate “A
c-
quire an image immediately when a driver is load-
ed
.” If this is omitted an error can occur when the
software is started. Please confirm
WriteToRegistry
to save your settings
Then you have to register the camera to the driver.
Please choose CameraSuite which you can find
under point 2-
Licensing
