5.2.2
H
YDRAULIC OIL FILTER
Change
The hydraulic oil filter
D
is located at the top of the hydraulic oil tank, behind the
distributor guard. Before opening the filter cover, remove the filler cap
B
(
see photo‐
graph Par. 5.3.1
) to avoid overpressurizing the tank.
To access this, after removing the distributor guard, remove the screws on the filter
cover and replace the cartridge.
5.2.3
T
RAVEL REDUCTION GEAR OIL
Checking the reduction gear oil level
The reduction gear oil level should be checked
every 100 hours. Stop the reduction gear with the
plugs aligned on the horizontal axis. Remove the
plugs as shown in Fig. A and check that the oil
level reaches the same height. If not, top up throu‐
gh one of the openings, using the other as level
reference.
Changing the reduction gear oil
The oil should be changed for the first time after
100 hours of operation, and the following times
every 1000 hours of operation. To change the oil,
proceed as follows:
‐ stop the reduction gear with the plugs aligned
vertically to the ground, as illustrated in Fig. B;
‐ remove both plugs and drain the oil completely;
‐ then position the reduction gear with the plugs
aligned on the horizontal axis (Fig. A) and fill
through one of the openings, using the other as
level reference.
Avoid using different oils in terms of characteristics and brand.
31
O
O
P
P
E
E
R
R
A
A
T
T
I
I
O
O
N
N
A
A
N
N
D
D
M
M
A
A
I
I
N
N
T
T
E
E
N
N
A
A
N
N
C
C
E
E
M
M
A
A
N
N
U
U
A
A
L
L
TP2000
MUTP2000171893021216
IMPORTANTE
A
B
IMPORTANT
