![background image](http://html.mh-extra.com/html/pro-point/9027525/9027525_manual_1607384008.webp)
9027525
Magnetic Drilling and Tapping Press
V1.0
8
For technical questions call 1-800-665-8685
Always remove tie, rings, watches and any loose adornments that
might entangle with the rotating machinery before operating.
Always ensure that long hair is securely enclosed by an approved
restraint before operating the machine.
Should the cutter become stuck in the work piece, stop the motor
immediately to prevent personal injury. Disconnect from power source
and turn arbor to and from. Do not attempt to free the cutter by
switching the motor on and off. Wear safety gloves to remove the
cutter from the arbor.
If the machine is accidentally dropped, always thoroughly examine the
machine for signs of damage and check that it functions correctly
before resuming drilling.
Regularly inspect the machine and check for any damaged or loose
parts.
Always ensure when using the machine in an inverted position that
only the minimum amount of coolant is used and that care is taken to
ensure that coolant does not enter the motor unit.
Cutting tools may shatter, always position the guard over the cutter
before activating the machine. Failure to do so may result in personal
injury.
On completion of the cut, a slug will be ejected.
When not in use always store the machine in a safe and secure
location.
Always ensure that approved Unibor™ agents conduct repairs.
The machines are factory fitted with a 9-3/4 ft cord with three conductors:
16 AWG, neutral and earth. If it becomes necessary to fit an extension
cable from the power source, care must be taken in using a cable of
adequate capacity. Failure to do so will result in a loss of traction by the
magnet and a reduction of power from the motor.
Assuming a normal AC supply of the correct voltage, it is recommended
that the following extension lengths shall not be exceeded.
For 120V supply:
11-1/2 ft of 3 core x 16 AWG