![background image](http://html.mh-extra.com/html/pro-point/9027525/9027525_manual_1607384013.webp)
V1.0
Magnetic Drilling and Tapping Press
9027525
Visit www.princessauto.com for more information
13
4. Position the machine on the centerline of the pipe, ensuring the
magnet is in line with the longitudinal axis of the pipe.
5. Switch the magnet and move the
sliding plates down to the outside
diameter of the pipe.
6. Tighten the screws on both sides on
both sides by hand.
7. Check once again that the full length of
the moving plates is touching the pipe
at the front and the back.
8. Fasten the plates securely.
9. Feed the safety strap through the lugs at the front of the housing
around the pipe and pull tight.
10. When cutting the hole, do not use excessive pressure.
This tool comes supplied with an arbor shank (RDC4087) and 1/2 in. chuck
(RDC4084).
1. Insert the arbor shank into the arbor spindle (RDC4009).
2. Ensure a tight fit.
3. Insert the 1/2 in. chuck into the arbor shank.
4. Ensure a tight fit.
To replace the chuck, simply reverse the above sequence, utilizing the drift
(RDC4086).
This tool accepts cutters with 3/4 in. diameter Weldon shanks. To mount
the cutters, accomplish the following:
1. With the tool in the upright position, ensure the arbor assembly
(CA120) is fully inserted into the arbor spindle (RDC4009).
2. Take appropriate pilot and place through the hole in the shank
(RDC4087).
3. Insert the shank of cutter into bore of arbor assembly, ensuring
alignment of the two drive flats with socket screws.
4. Tighten both screws using hexagon key.
Fig. 6