Orion
Machine Manual
Revision 3.1
Sentry HP/ LP Flex Stretchwrapper
21 May 2020
System Operation
Page 3-11
Wrap Setting Screens
Wrap Settings Screen
Note:
To adjust the wrap settings, you must be logged in. Press the login
button in the bottom left corner of the screen. Enter ADMIN then
press the checkmark, then X to close the keypad.
This is the Wrap Settings screen. This screen allows you to set the number of top and bot-
tom wraps and the speed percentage of the carriage up and down travel. You may also
choose wrap pattern options such as, Wrap Bottom First, Wrap Top First, Low Speed/
High Speed, Unstable Load Enabled or Disabled, Autoheight Enabled or Disabled, or
Film Fault Enabled or Disabled. You can view each pattern settings on the Recipe Viewing
Screen, see “Sentry Carriage Recipe Viewing Screen” on page 3 - 17.
Figure 3 - 10
The Wrap Settings
Screen
Table 3-6. The Wrap Settings Screen Button Descriptions
STATE 1
DESCRIPTION
STATE 2
TOP WRAPS
Press this button to set the number of top wraps applied to the load. Parameters are
1-20.
BOTTOM WRAPS
Press this button to set the number of bottom wraps applied to the load. Parameters
are 1-20.
CARRIAGE UP SPEED
Press this button to change the speed of the carriage on the upward move, in terms
of percentage. Min - 5% Max - 100%
