Orion
Machine Manual
Revision 3.1
Sentry HP/ LP Flex Stretchwrapper
21 May 2020
System Operation
Page 3-7
Press this button to resume the wrap cycle, if the cycle is currently paused.
Press this button to either stop the current wrap cycle or reset any displayed faults.
Press this button to apply the predefined reinforce-
ment wraps to the load. If the Reinforcement Wraps
value is set to zero, reinforcement wraps will be
applied as long as the Reinforce button is pressed.
REINFORCING
Press this button to toggle between High Speed and Low Speed operation. When
High Speed is selected, the Main Drive will travel at the predefined High Speed
value during the wrap cycle. When Low Speed is selected, the Main Drive will
travel at the predefined Low Speed value during the wrap cycle.
Press this button to send the machine to its Home Position. When pressed, the Car-
riage will travel to its bottom limit, and the Main Drive will travel to its predefined
End of Cycle Position.
Table 3-2. The Run Screen Button Descriptions (Continued)
STATE 1
DESCRIPTION
STATE 2
