Machine Manual
Orion
Sentry HP/ LP Flex Stretchwrapper
Revision 3.1
System Operation
21 May 2020
Page 3-50
CARRIAGE GATE
OPEN
The carriage gate is currently open.
Close the carriage to allow oper-
ation. Check the interlock
switch.
HOMING MACHINE
The machine is homing.
Allow the machine to home prior
to starting.
PRESS START
BUTTON TO RESET
CONTROL POWER
The machine is not reset.
Press Start to reset control power
prior to starting.
MOVING TO BOTTOM
OF LOAD
The carriage is moving to the bottom of the load.
This is for informational pur-
poses only. No correction neces-
sary.
MOVING TO TOP OF
LOAD
The carriage is moving to the top of the load.
This is for informational pur-
poses only. No correction neces-
sary.
READY TO
WRAP - PRESS & HOLD
START BUTTON
The machine is reset and ready to run.
Press and hold the start button
for the amount of time set in the
parameters to start the machine.
APPLYING
REINFORCEMENT
WRAPS
Reinforce wraps are currently being applied.
Once the reinforce wraps are
completed, the machine will
continue its cycle.
TOWER OBSTACLE
DETECTED
The tower has an obstruction.
Check for a mechanical bind.
Clear the cause of the fault.
Reset and restart, when ready.
APPLYING BOTTOM
WRAPS
The bottom wraps are currently being applied.
This is for informational pur-
poses only. No correction neces-
sary.
WRAP CYCLE IS
COMPLETE
The wrap cycle is now complete.
Remove the load, when ready.
INITIALIZING
The machine is initializing.
There is a brief initialization
sequence once the machine is
reset. Allow the machine to ini-
tialize prior to starting.
SAFETY SYSTEM NOT
READY
The safety controller is not ready to run.
Allow the safety system to ini-
tialize prior to running.
Table 3-36. The Information and Alarm Displays (Continued)
MESSAGE
DESCRIPTION
CORRECTION
