Machine Manual
Orion
Sentry HP/ LP Flex Stretchwrapper
Revision 3.1
System Operation
21 May 2020
Page 3-26
Main Drive Screen
This is the Main Drive screen. This screen allows adjustment of the Main Drive (turnta-
ble.)
Figure 3 - 21
The Main Drive
Screen
Table 3-17. The Main Drive Screen Button Descriptions
STATE 1
DESCRIPTION
END OF CYCLE
POSITION
Press this button to modify the End of Cycle Position value. This value determines
the tooth count position at which the Main Drive will stop at the end of a wrap
cycle, or when the Home Machine button is pressed. Min - 0 Max - 50
SLOWDOWN POSITION
The slow down position is when the turntable starts to decel before stopping at
home. An earlier slow down position might be needed for heavier loads and a later
slowdown position for lighter loads. The value is the tooth count in which the
machine will start to decelerate.
Press this button to send the machine to its Home Position. When pressed, the Car-
riage will travel to its bottom limit, and the Main Drive will travel to its predefined
End of Cycle Position.
HIGH SPEED
Press this button to modify the High Speed value, in terms of percentage. This value
determines the speed at which the Main Drive will travel during the wrap cycle
when High Speed is selected. Min - 1% Max - 100%.
LOW SPEED
Press this button to modify the Low Speed value, in terms of percentage. This value
determines the speed at which the Main Drive will travel during the wrap cycle
when Low Speed is selected. Min - 1% Max - 100%.
