Printronix S828, Programmer'S Manual

Page: 70 / 424

Programmer Manual PTX ‐ S828
Chapter 2 Native Emulation Commands 68 260071 ‐ 001A
n Selection
0 Selects and loads the fanfold from the Front1 path. If the paper is present (cut sheet/fanfold), the
printer automatically parks this fanfold that is not requested before loading the new one (after having
pressed the PARK key in response to the TEAR IF NECESS/PARK PAPER message).
1 Parks the fanfold loaded from the Front1 path to allow the tear off function (after having pressed the
PARK key in response to the TEAR IF NECESS/PARK PAPER message).
DC4 DC4 ESC Y
Selects emulation.
ASCII Code
DC4 DC4 ESC Y n
Hexadecimal Value X'14' X'14' X'1B' X'59' n
Decimal Value 20 20 27 89 n
Selects the printer emulation type according to the n parameter value:
n Emulation
0 Default printer emulation
1 EPSON FX Series
2 IBM Proprinter XL III
5 IBM 2381+
DC4 DC4 ESC Z
Makes AGA in column.
ASCII Code
DC4 DC4 ESC Z n
Hexadecimal Value X'14' X'14' X'1B' X'5A' n
Decimal Value 20 20 27 90 n
The n parameter is the column number at 10 cpi where the AGA (Automatic Gap Adjustment) is made.
DC4 DC4 ESC u
Selects the user macros.
ASCII Code
DC4 DC4 ESC u n
Hexadecimal Value X'14' X'14' X'1B' X'75' n
Decimal Value 20 20 27 117 n
Range
0 = n = 4
n Selection
1 Selects User Macro 1
2 Selects User Macro 2
4 Selects User Macro 3
5 Selects User Macro 4
DC4 DC4 ESC D
Sends the operator panel messages to the serial I/F.
ASCII Code
DC4 DC4 ESC D n
Hexadecimal Value X'14' X'14' X'1B' X'44' n
Decimal Value 20 20 27 68 n