Printronix S828, Programmer'S Manual

Page: 220 / 424

Programmer Manual PTX ‐ S828
Chapter 6 IPDS Exception Reporting Codes 218 260071 ‐ 001A
Specification Check-Graphics - X'03'
The following exception codes are the valid codes for a graphics specification check condition:
X'030001' Unallocated Graphic Order or
Command Code
Explanation:
1. An attempt was made to execute an unallocated
order code that is reserved for future use.
2. An attempt was made to execute an unallocated
command code that is reserved for future use.
Alternate Exception Action:
None.
X'030002' Reserved Byte Error or Invalid
Default
Explanation:
1. A reserved byte in the graphic order is not set
to zero.
2. The Set Current Defaults instruction attempts,
in byte 2, to set an invalid or unsupported
attribute.
3. An invalid default byte value was received in
the GDD.
Alternate Exception Action
: None.
X'030003' Incorrect Drawing Order Length
Explanation:
A drawing order length is invalid.
Alternate Exception Action:
None.
X'030004' Invalid Attribute Value
Explanation:
An attribute value for a graphic
order or for a WGC Set Current Default
instruction is invalid.
Alternate Exception Action
: Use the standard
default value for that attribute.
X'030008' Truncated Order Error
Explanation:
An order has been requested that is
not a complete order. This order is one of the
following:
1. A fixed 2-byte order and the second byte is not in
the segment.
2. A long order and the length byte is not in the
segment.
3. A long order and the number of bytes following
the byte containing the length count to the end of
the segment is less than the value of the length
count.
Alternate Exception Action:
None.
X'03000C' Segment Prologue Error
Explanation
: A supported order that is not valid
within a prologue was found in a prologue.
The end of a segment was reached without an
End Prologue order.
Alternate Exception Action:
None.
X'03000E' Unsupported Attribute Value
Explanation:
An attribute value for a graphic order
or for a WGC Set Current Default instruction is not
supported.
Alternate Exception Action:
Use the standard
default value for that attribute.
X'0300021' Invalid Default
Explanation:
The Set Current Defaults
instruction sets an invalid or unsupported
default for an attribute.
Alternate Exception Action:
None.
X'033400' Character Angle Value Not Supported
Explanation:
The specific character angle
requested is not supported.
Alternate Exception Action
: Use the closest angle
supported by the printer.
X'033E00' Invalid End Prologue
Explanation:
An End Prologue was found
outside the prologue section of a segment.
Alternate Exception Action:
None.
X'036000' Area Bracket Error
Explanation
: An End Area order has been
executed without a Begin Area order having
previously been executed.
Alternate Exception Action:
None.
X'038000' Begin Area Received Incorrectly
Explanation:
Begin Area order received while
Begin Area is already in progress.
Alternate Exception Action:
None.