Printronix S828, Programmer'S Manual

Page: 54 / 424

Programmer Manual PTX ‐ S828
Chapter 1 EPSON/IBM Commands 52 260071 ‐ 001A

To go back to the current printer setup settings

To cancel any selected print attributes

To reset the column counter

To set the horizontal tabulations every 8 columns

To clear all vertical tabulations
Only the selection of the Draft or Quality printing DLL, and the selected character generator are
maintained.
ESC[ K
Sets initial conditions. (IBM 2381 + only)
ASCII Code
ESC [ K n1 n2 init id
Hexadecimal Value X'1B' X'5B' X'4B' n1 n2 init id
Decimal Value
27 91 75 n1 n2 init id
This command causes the printer to reset to its initial status:
n1, n2
The n1 and n2 parameters specify the number of bytes in the escape sequence normally,
n1 = 2 and n2 = always 0.
init
The init parameter specifies which condition the printer should be initialized: normally init =
0,1,4,5,254,255.
init Description
0 Initializes the printer to user-default settings. The download font remains unchanged.
If parameters are specified, they overwrite the default settings. If the emulation mode
is changed, the download font is initialized. This command only copies data from the
selected macro, adds parameter changes, if any, and stores it in working RAM. The
data stored in the macro's nonvolatile RAM is not affected.
1 Initializes the printer to user-default settings. The download font is initialized. If
parameters are specified, they overwrite the default settings. This command only
copies data from the selected macro, adds parameter changes, if any, and stores it
in working RAM. The data stored in the macro's nonvolatile RAM is not affected.
4 Initializes the printer to factory settings. The download font remains unchanged. If
parameters are specified, they overwrite the default settings. If the emulation mode
is changed, the download font is initialized. This command only copies the default
settings from ROM, adds parameter changes, if any, and stores it in working RAM.
The data stored in the macro's nonvolatile RAM is not affected.
5 Initializes the printer to factory settings. The download font is initialized. If
parameters are specified, they overwrite the default settings. This command only
copies the default settings from ROM, adds parameter changes, if any, and stores it
in working RAM. The data stored in the macro's nonvolatile RAM is not affected.
254 Initializes the printer to user-default settings. The download font is initialized. If
parameters are specified, they overwrite the default settings.
This command changes the data stored in the selected macro. It copies data from
the selected macro, adds parameter changes, if any, and stores it in working RAM
and in the selected macro. It also changes the default macro to the value of parm 3.