Printronix S828, Programmer'S Manual

Page: 31 / 424

Programmer Manual PTX ‐ S828
Chapter 1 EPSON/IBM Commands 29 260071 ‐ 001A
Print Mode
DC2
Sets 10 cpi printing. (IBM)
ASCII Code
DC2
Hexadecimal Value X'12'
Decimal Value 18
This is a terminator code. It causes all data present in the print buffer to be printed. This command is
accepted at any position within the line. The character that follows this command is printed at 10 cpi.
DC2
Cancels compressed printing. (EPSON)
ASCII Code
DC2
Hexadecimal Value X'12'
Decimal Value 18
This is a terminator code. It causes all data present in the print buffer to be printed. This command is
accepted at any position within the line. The character that follows this command is printed as follows:
17 CPI . 10 CPI
20 CPI . 12 CPI
DC4
Cancels double width printing (IBM/EPSON).
ASCII Code DC4
Hexadecimal Value X'14'
Decimal Value 20
This code cancels the double width printing set by SO or ESC SO code. It has no effect if the ESC W or
ESC ! command is set to double width.
ESC -
Sets or cancels underlined printing (IBM/EPSON).
ASCII Code
ESC - n
Hexadecimal Value X'1B' X'2D' n
Decimal Value 27 45 n
Enables or disables underlined printing. See the following table:
n
Underlined Printing
1 enabled
0 disabled