Install Penetrating Antenna Kit
The Penetrating Antenna Kit contains the materials required to mount the antenna to a wooden pole or masonry wall. A
5/8" (1.58 cm) diameter mounting hole is required and the maximum diameter of the pole or wall thickness is 14" (35.56
cm).
Kit Contents
The kit is supplied with the following parts. If any of these items are missing, please contact Primex Wireless.
Description
Qty
Rigid galvanized conduit section | 5’ by 1.25”
1
Rigid galvanized conduit insert (5’ by 1”)
1
Antenna mounting clamp
2
Hex head bolt | 1/2"
2
Bolt washer | 1/2"
8
Lock washer | 1/2"
8
Hex nut | 1/2"
8
Mounting Antenna Using Penetrating Antenna Kit
Complete the steps below to mount the antenna using a penetrating antenna kit.
NOTE:
The recommended diameter of the pole or the wall thickness should not exceed 14" (35.56 cm).
1. Verify the kit contents.
2. Assemble both clamps, as shown in the figure below, tightening the hex nuts to a torque of approximately 45ft-
lbs.
Figure 4: Wall Mount
3. Remove the nut and washer from 14” threaded rod.
4. Drill a 5/8” hole through the top of an exterior wall.
Primex Wireless
UK 1/2 and 5 Watt Transmitter - External Antenna Installation & User Guide
18
