Mount the Antenna Mast
NOTE:
Mounting the antenna mast may require two people.
There are three available mounting methods. Installation is dependent upon the mounting kit supplied with the system.
l
For additional information, see "Assemble Non-Penetrating Antenna Mount" located on page 16.
l
For additional information, see "Install Penetrating Antenna Kit" located on page 18.
l
For additional information, see "Install Antenna Pole Mount Kit" located on page 20.
Assemble Non-Penetrating Antenna Mount
The Non-Penetrating Antenna Kit is designed for mounting a ground plane omnidirectional antenna when mounting to
the side of a structure is not practical. The overall footprint of the frame is 29” X 35 ½" (73.66 cm x 88.9 cm).
NOTE:
Installation requires six 8" x 8" x 16" concrete blocks (not supplied).
Kit Contents
The kit is supplied with the following parts. If any of these items are missing, please contact Primex Wireless.
Description
Qty
Rigid galvanized conduit mast | 5’ by 1.25” (1.5 2 m x 3.17
cm)
1
Tripod leg | 27"(2.54 cm) each in length
3
Frame rail (long) | 34 ¾”(88.26 cm)
2
Frame rail (short) | 28 ¼” (71.75 cm)
4
Grounding Clamp
1
Long carriage bolt
1
Short carriage bolt
11
Flat washers
12
Lock nuts
12
Assemble Non-Penetrating Antenna Mount
Complete the steps below to assemble a non-penetrating antenna mount.
1. Verify kit contents.
2. Assemble the outer frame by laying the 2 long frame rails parallel to each, approximately 30" (76.2 cm) apart.
3. Insert a short carriage bolt from the bottom at each frame rail end, pointing skyward (4 total).
4. Connect the 2 long frames rails by placing the 2 short frame rails on top of the 4 protruding bolts to form a
rectangle. Make sure the square holes in the short tail "sides" are directly opposite each other.
Primex Wireless
UK 1/2 and 5 Watt Transmitter - External Antenna Installation & User Guide
16
