PRIMERGY TX300 S3, Operating Manual

Page: 102 / 125

102 Operating Manual
TX300 S3
Hot-pluggable PCI boards Hot plug components
Ê Activate the board either using the relevant software or by pressing the
waveguide (b).
The power indicator for the hot-plug PCI slot (see table 2 on page 68 )
flashes green. The slot is in an enable sequence.
Ê Wait until the power indicator is lit and steady. The slot is now powered on.
I
If the boards do not match, the new board will not be commissioned
(see
section “Hot-plug PCI voltage display does not light up after the
board has been replaced” on page 84 ).
Ê Replace the left side cover (floorstand model) or the housing cover (rack
model) (see
section “Opening/Closing the Housing” on page 107 ).
8.4.2 Remove the hot-pluggable PCI board from the
removal tool
Figure 35: Remove the hot-pluggable PCI board from the removal tool
Ê
Lift the movable green engaging hooks no more than about 1 mm (1), until
the PCI board is completely released.
Ê Remove the PCI board from the removal tool (2).
1
1
1
2